Homelink ® Wireless Control System* - Programming - Volvo S 80 Owner's Manual

Using HomeLink
To operate, simply press and hold the pro-
grammed HomeLink button until the trained
device begins to operate (this may take sev-
eral seconds). Activation will now occur for
the trained device (i.e., garage door opener,
gate operator, security system, entry door
lock, home/office lighting, etc.). For conven-
ience, the hand-held transmitter of the device
may also be used at any time. In the event
that there are still programming difficulties or
questions, contact HomeLink at:
www.homelink.com or by phoning the hotline
at 1–800–355–3515.
NOTE
If the ignition is switched off, HomeLink
will function for 30 minutes after the driv-
er's door has been opened.
HomeLink and the HomeLink house are registered trademarks of Johnson Controls, Inc.
21
®
HomeLink Wireless Control System*
– programming
The HomeLink 21 Wireless Control System
provides a convenient way to replace up to
three hand-held radio-frequency (RF) trans-
mitters used to activate devices such as gate
operators, garage door openers, entry door
locks, security systems, even home lighting.
Additional information can be found on the
Internet at www.homelink.com or by phoning
the hotline at 1–800–355–3515.
NOTE
Some vehicles may require the ignition to
be switched on or be in the "accessories"
position for programming and/or operation
of HomeLink. It is also recommended that
a new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker training
and accurate transmission of the radio-fre-
quency signal. The HomeLink buttons
must be reset first. When this has been
completed, Homelink is in learning mode
so that you can perform programming.
1. Position the end of your hand-held trans-
mitter 1–3 inches (5–14 cm) away from
the HomeLink button you wish to pro-
gram while keeping the indicator light in
view.
03 Instruments and controls
2. Simultaneously press and hold both the
chosen HomeLink and hand-held trans-
mitter buttons until the HomeLink indica-
tor light changes from a slow to a rapidly
blinking light. Now you may release both
the HomeLink and hand-held transmitter
buttons.
NOTE
Some devices may require you to replace
this Programming Step 2 with procedures
noted in the "Gate Operator / Canadian
Programming" section. If the HomeLink
indicator light does not change to a rapidly
blinking light after performing these steps,
contact HomeLink at www.homelink.com
or by phoning the hotline at
1–800–355–3515.
*
Option/accessory, for more information, see Introduction.
03
}}
103