Cabling; Touchpad - Medion AKOYA E7222 Instruction Manual

16

Cabling


Arrange cables so that no one can walk on or trip over them.

Do not place objects on any of the cables.

To avoid damage to your notebook, connect your peripherals (e.g. keyboard, mouse
and monitor) whilst your notebook is powered off. Some devices can be connected
whilst your notebook is in use. These devices usually have a USB connector. Please
follow the appropriate instructions for each device.

Keep the notebook at least 1 metre (approximately 3 feet) away from high frequency
and magnetic interference sources (e.g. televisions, loudspeaker cabinets, mobile
telephones, etc.) in order to avoid malfunctions and/or loss of data.

Please note that only shielded cables shorter than 3 metres (9.84 ft) should be used
for the LPT, COM, USB, IEEE 1394, audio, video and network interfaces with this
notebook. When connecting a printer to your notebook, please only use a printer
cable with double shielding.

Only use power cables/connection cables supplied with the notebook and its devices
as the cables have been extensively tested.

It is recommended to disconnect any cables from your notebook that are not
connected to a peripheral device or are not in use.

Only devices complying with the following safety requirements should be connected
to your notebook: "AS/NZS 60960 Safety of information technology equipment" or "
AS/NZS 60065 Audio, video and similar electronic apparatus".

Touchpad


Light pressure with the tip of your finger is all that is required to operate the
touchpad. Because the touchpad is electrostatic sensitive, objects cannot be used in
place of your fingers. Using a pen or other object can damage the touchpad or cause
the notebook to malfunction.
After Sales Support TEL: 1300 884 987 WEB Support: www.medion.com.au