Omega i Series User Manual page 59

UNIT SUBMENU (not applicable):
Press d
Press b
Press d
ADDRESS SETUP SUBMENU:
This menu is applicable to the RS-485 Option only.
Press d
ADDRESS VALUE SUBMENU:
Press d
Press b & c 55) Press b and c to enter new "Address Value".
Press d
TRANSMIT TIME INTERVAL SUBMENU:
This menu is applicable if "Continuous" Mode was selected in the "Data
Flow Mode" Submenu and the device is configured as an RS-232C
Standard device. Also, one or more options under the Data Format
Submenu must be enabled.
Press d
TRANSMIT TIME INTERVAL VALUE SUBMENU:
Determines the interval at which data will be emitted to the RS-232 Serial Bus
when the instrument is in Continuous Data Flow Mode.
Press d
Press b & c 59) Press b and c to enter new "Transmit Time Value", e.g.
Press d
For more details, refer to the Communication Manual available at
the website listed on the cover page of this manual or on the
CD-ROM enclosed with your shipment.
50) Display flashes previous selection for UNIT .
51) Scroll through the available selections: NO, YES.
52) Display shows STRD stored message momentarily and then
advances to ADDR only, if it was changed, otherwise press a to
advance to ADDR Address Setup Submenu.
53) Display advances to "Address Value" (0000 to 0199)
Submenu.
54) Display flashes 1
56) Display shows STRD stored message momentarily and then
advances to TR.TM only, if it was changed, otherwise press a
to advance to TR.TM Transmit Time Interval Submenu.
57) Display advances to "Transmit Time Value" Submenu.
58) Display flashes 1
seconds.
0030 will send the data every 30 seconds in Continuous Mode.
60) Display shows STRD stored message momentarily and then
advances to COLR only, if it was changed, otherwise press a to
advance to COLR Color Display Selection Menu.
st
digit of previously stored Address Value.
st
digit of previous "Transmit Time Value" in
55