Sub-Zero BI-36R Use & Care Manual page 23

Built-In Use & Care
Ice and Water Dispenser
EXTERNAL DISPENSER MODELS
For external dispenser models BI-42SD and BI-48SD, the
ice and water dispenser in the refrigerator door gives you
both ice and chilled water without having to open the door.
IMPORTANT NOTE: Make sure the dispenser key pads are
clean and dry to avoid problems with dispenser operation.
The water tank holds approximately 50 oz
chilled water. After the tank has been filled for the first
time or if all 50 oz
(1.5 L)
drops of water may collect in the removable water grille
which is located at the bottom of the glasswell. Because
there is no drain in this area, do not pour water into the
water grille.
To operate the external dispenser, set a glass on the water
grille of the glasswell. For ice, press and hold the ICE key
pad on the glasswell until you have the ice you need. For
water, press and hold the WATER key pad until the glass is
filled. Refer to the illustration below.
Models BI-42SD and BI-48SD have a feature that limits
the maximum amount of ice that is dispensed each time
the ICE key pad on the glasswell is pressed.
For metered ice, hold the ICE key pad for approximately
two seconds. The dispenser will meter out ice for about
two seconds, collect the ice directly above the glass, then
drop the ice into the glass. If less ice is desired, hold the
ICE key pad for less than two seconds. For more ice, hold
the ICE key pad until the dispensing cycle repeats.
ICE
WATER
LOCK
INDICATOR
LIGHT
WATER
GRILLE
BEZEL
External dispenser glasswell.
(1.5 L)
have been dispensed at one time,
BULK ICE
KEY PAD
Bulk ice dispenser.
For larger quantities of ice, open the refrigerator door and
place an ice container under the dispenser chute located
on the left interior wall of the refrigerator section. Press the
BULK ICE key pad on the dispenser until you have the ice
you need. Refer to the illustration.
Limit continuous ice and water dispenser operation to
of filtered,
seven minutes or less, to avoid damage to the unit.
DISPENSER LIGHT
For models BI-42SD and BI-48SD, there are three lighting
states that can be cycled by pressing the LIGHT key pad
on the glasswell; all lights OFF, all lights ON (blue key pad
and white glasswell) and key pad lights ON only.
During water or ice dispensing, all lights will illuminate
until dispensing is complete, then lights will return to their
previous state.
DISPENSER LOCK
For models BI-42SD and BI-48SD, the lock feature is used
to prevent unintended ice and water dispensing. When the
dispenser is locked, all key pads on the glasswell are
deactivated to allow for cleaning or to prevent small
children from using the dispenser.
To activate the lock feature, hold the LIGHT key pad on
the glasswell until the key pad lights flash once and the
red LOCK icon is illuminated (approx five seconds). The
lights will remain in the state they were in before the lock
feature was activated.
To deactivate the lock feature, hold the LIGHT key pad
until the key pad lights flash once and the red LOCK icon
is no longer illuminated (approx five seconds). The lights
will remain in the state they were in before the lock feature
was deactivated.
23
subzero.com