Ice And Water Dispenser - Sub-Zero BI-36R Use & Care Manual

Built-In Use & Care

Ice and Water Dispenser

INTERNAL DISPENSER MODELS
For internal dispenser models BI-42SID and BI-48SID,
ice and chilled water is provided through the dispenser in
the refrigerator section of the unit. The refrigerator door
must be opened to access the dispenser.
IMPORTANT NOTE: Make sure the dispenser key pads are
clean and dry to avoid problems with dispenser operation.
The dispenser was designed to accommodate a 16-oz
pint glass. Larger containers may be used however
(.5 L)
some may be too large which could compromise the
effectiveness of the dispenser.
The water tank holds approximately 50 oz
chilled water. After the tank has been filled for the first
time or if all 50 oz
(1.5 L)
drops of water may collect in the removable water grille
which is located on the shelf directly below the dispenser.
(1.5 L)
have been dispensed at one time,
To operate the internal dispenser, open the refrigerator
door and place a glass under the dispenser chute, located
on the left interior wall of the refrigerator section. For ice,
press and hold the ICE key pad on the dispenser until
you have the ice you need. For water, press and hold
the WATER key pad until the glass is filled. Refer to the
illustration below.
Limit continuous ice and water dispenser operation to
seven minutes or less, to avoid damage to the unit.
of filtered,
ICE
KEY PAD
WATER
GRILLE
Internal dispenser.
WATER
KEY PAD
22