Icom iC-F3033S Instruction Manual page 12

2
PANEL DESCRIPTION
TALK AROUND KEY
Push to turn the talk around function ON and OFF.
receive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
Push to toggle the IF bandwidth between wide and narrow.
DTMF AUTODIAL KEY
Push to enter the DTMF channel selection mode. Then se-
lect the desired DTMF channel using [CH Up]/[CH Down].
After selecting the desired DTMF channel, push this key to
transmit the DTMF code.
RE-DIAL KEY
Push to transmit the last-transmitted DTMF code.
CALL KEYS
Push to transmit a 2-tone.
pending on your signaling system.
ploys selective 'Individual/Group' calls. Ask your dealer which call
is assigned to each key.
LONE WORKER KEY
Push to turn the Lone Worker function ON or OFF.
is automatically turned ON after the specified time period has
passed with no operation is performed.
TX CODE CHANNEL UP/DOWN KEYS
Push to select a TX code channel directly.
7
EMERGENCY KEY
Push and hold to transmit the emergency call.
depending on the presetting. Ask your dealer for details.
text is displayed on the LCD if programmed.
again before transmitting the call.
receiving a control code, depending on the presetting.
SURVEILLANCE KEY
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE CHANNEL SELECT KEY
-
Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
-
(p. 11)
USER SET MODE KEY
Push and hold for 1 second to enter user set mode.
is enabled by your dealer, and change the value or condition by
pushing [CH Up] or [CH Down].
Push and hold this key for 1 second again to exit user set
mode.
User set mode is also available via the 'Power ON function.'
Refer to page 8 also.