Table of Contents
Advertisement
Setup
Before you begin:
Make sure the Unit is connected to Antenna or Cable.
1
Press Q and use H I to select Setup, then press OK.
Picture
Autoprogram
Sound
Channel list
Add channels
Setup
Features
Antenna
Language
USB
2
Adjust the following items.
Autoprogram
Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
1
Use H I to Select Autoprogram, then press OK.
If you run Autoprogram when you have Locked Channels, a
●
Message appears asking to enter your PIN. Enter your PIN in order
to Complete the Installation. You need to reset or set the Channel
Lock again after the Installation.
2
Use H I to Select an appropriate Option, then press OK.
When Antenna is selected, the TV Detects Any Off-the-Air
–
Antenna Signals. It searches for ATSC (Digital) and NTSC
(Analog) Channels available in your Area.
When Cable is selected, the TV detects signals supplied by
–
Cable. It searches for DTV, Analog TV and Cable channels
available in your area.
Picture
Auto program will rescan all channels.
Auto programming may take more
Sound
than 20 minutes to complete.
Setup
Features
Select your signal source.
Language
Antenna
USB
Cable
Back
Antenna
Cable
Or
ANTENNA IN
Autoprogram
Please wait while the system is scanning for
channels.
Auto programming may take more than 20 minutes
to complete.
75%
Digital channels
Analog channels
When the Scanning and Memorizing of Available Channels is
●
Completed, the Lowest Memorized Channel will be Displayed.
Note(s)
After setting Autoprogram, using CH + / – skips unavailable channels Automatically.
●
If you are not receiving a signal from your Cable service, contact the Cable provider.
●
If you press B or Q during Autoprogram, the Setup of TV channels will be Cancelled.
●
Even if Autoprogram is completed, the channel setting will be lost if the AC Power Cord
●
is unplugged before the Unit goes into Standby mode by pressing B.
The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.
●
L p. 28
If you want to change your PIN code, follow the instruction for Change PIN. L
●
p. 30
Channel list
The channels selected here can be skipped when selecting the channels
using CH + / –.
Those channels can still be selected with the NUMBER keys.
1
Use H I to select Channel list, then press OK.
2
Use H I to select the channel you want to remove, then press
OK.
Picture
Sound
Highlight channels for Ch Up/Down
key selection.
Setup
Features
Language
USB
Ch Select
The channel display for the removed channel darkens. You will not
●
be able to select the channel again using CH + / –.
To reactivate a removed channel, use H I and press OK. The
●
registered channels are highlighted.
When you remove a main channel, its subchannels are removed
●
as well.
Note(s)
The channel with DTV indicated on the display is ATSC. Otherwise the channel is Analog
●
TV (NTSC).
25
10 ch
6 ch
Exit
DTV
11.1
DTV
11.2
DTV
11.3
Watch / Skip
Back
Continued on next page.
.
English
Advertisement
Table of Contents
