Table of Contents
Advertisement
These Operations are accessible by Remote Control.
Some may also be accessible by the Main Unit's Control Panel.
Initial Setup
This section will guide you through the Unit's Initial setting which includes
selecting a Language for your On-screen Menu and Autoprogram, which
Automatically scans and memorizes viewable channels.
Before you begin:
Make sure the Unit is connected to an Antenna or Cable.
1
After making All the Necessary Connections, press B to Turn On
the Unit.
It may take a few moments to Turn On the Unit for the first time.
●
Initial setup menu appears Automatically after the Unit is Turned
●
On.
2
Use H I to select the On-screen language from the choices
(English / Español / Français) on the right side of the TV screen, then
press OK.
3
Use H I to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Initial setup
Make sure the antenna is connected to "ANTENNA IN"
jack.
Select your signal source.
Antenna
Cable
Or
Select
OK
When Antenna is selected, the TV detects Antenna signals. It
–
searches for DTV and Analog TV channels available in your area.
When Cable is selected, the TV detects signals supplied by
–
Cable. It searches for DTV, Analog TV and Cable channels
available in your area.
Autoprogram will begin.
●
Initial setup
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to
complete.
0%
Digital channels
Analog channels
Antenna
Cable
Skip
ANTENNA IN
Back
Skip
0 ch
0 ch
Skip
4
Use H I to select the desired Location setting, then press OK.
Initial setup
Location Home is recommended for normal home use.
In the Retail Store mode, all settings are fixed.
##
Select
Select Home, the Unit is set to maximize the energy efficiency for
●
home setting and it can be adjusted through a choice of Picture
and Sound quality according to your preference. Use this setting
to remove the E-sticker, if visible on the display. L p. 32
You must set Home in step 4. Otherwise, Picture and Sound
●
settings you adjusted will not be memorized after the Unit goes
into Standby mode.
When the Initial setup is completed, the Lowest Memorized
●
Channel with the confirmation message of the Location setting will
be displayed on the TV screen.
Select Retail, the Unit will be set up with predefined settings for
●
retail displays.
5
When you select Home, press OK to begin Settings assistant.
Settings assistant
Settings assistant helps you customize picture settings.
You will see a series of test pictures where the right side
and left side differ. Select the side that is most pleasing to
you with the Left/ Right keys.
Next
6
Press J or K 3 times to select the side of the pictures that is the
most pleasing to you, then press OK.
Left side
1/3 Select the picture setting that you prefer.
Select
Next
16
Retail
Home
OK
Back
Exit
Right side
Back
Exit
Continued on next page.
.
English
Advertisement
Table of Contents
