Watching Channels from an External Device
Switching Each Input Mode can easily switch with the Remote Control
between TV (DTV or Analog TV) and External Devices when they are
connected to the Unit.
1
Turn On a Set-top Box or the Connected Device.
The picture from the Set-top Box or the Connected Device might
●
appear Automatically on the TV screen.
If the picture does not appear
① Press S SOURCE Repeatedly to select the Set-top Box or the
connected device and wait a few seconds till the Picture appears.
e.g.)
11.1
TV
DTV / Analog TV
HDMI1
channel
HDMI2
HDMI3
Video
PC
PC
Pressing H reverses the direction of the Input modes.
●
② Use the Remote Control for the Set-top Box or the Connected
Device to select Channels to view.
Access the Home menu
1
Press Q (MENU).
Guide to Home menu
a
Watch TV
Browse USB
b
Net TV
Add new devices
c
a Watch TV
: Switches back to the TV source if another
source is selected.
b Net TV
: Accesses Net TV menus.
c Add new devices
: Adds new devices to the Home menu.
d Browse USB
: Accesses USB menus.
e Browse PC
: Accesses DLNA menus.
f Setup
: Accesses menus that allow you to change
picture, sound and other TV settings.
HDMI1
HDMI2
Video
or
HDMI3
Component
d
e
Browse PC
f
Setup
Note(s)
After selecting Add new devices, follow the on-screen instructions to select the correct
●
device and connector.
Lock or unlock your device from the Home menu
This section describes how to lock or unlock specified device.
1
Press Q (MENU) on the remote control.
2
Use H I J K to select a device to lock or unlock.
3
Press U OPTIONS on the remote control.
4
Use H I to select Device lock or Device unlock, then press OK.
If device lock is unlocked, Device lock will be displayed. If device
●
lock is locked, Device unlock will be displayed and
displayed at the top right of the device icons.
5
Enter your PIN. Change PIN L p. 33
Once you have set PIN, PIN input menu does not appear after the
●
unit is Turned on.
Enable or disable RC key forwarding from the Home menu
This section describes how to enable or disable RC key forwarding for a
particular device.
1
Press Q (MENU) on the remote control.
2
Use H I J K to select a device to enable or disable RC key
forwarding.
3
Press U OPTIONS on the remote control.
4
Use H I to select Enable RC key forwarding or Disable RC key
forwarding, then press OK.
If RC key forwarding is set to off, Enable RC key forwarding will
●
be displayed. If RC key forwarding is set to on, Disable RC key
forwarding will be displayed and
left of the device icons.
Note(s)
This function is available only when your devices are connected to this unit through HDMI
●
cables and assigned to an HDMI port (HDMI 1 to HDMI 3) with Add new devices in the
Home menu.
20
.
English
will be
will be displayed at the top