Back Panel - Honeywell Dolphin 6510 User Manual

Back Panel

DC Power Jack
Use the power cable from Honeywell that comes with the Net Base to supply power to this
power jack. For more information, see
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into one of the two Ethernet ports provided. The second RJ45
Ethernet port can be used for connection to an additional device such as a printer, workstation,
eBase, or another Net Base.
Note: The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports
are used, do not connect both Net Base interfaces to the same layer 2 LAN.
Each Ethernet port has a dedicated green and yellow status LED.
This color
Green
Yellow
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices
and/or the Internet. For more information, see
Two RJ45 Ethernet Ports
and status means...
Flashing Data transfer is in progress.
Solid A connection has been established between the Net Base and
the Ethernet.
Solid Ethernet is connected at 100T.
Off Ethernet is connected at 10T.
Green LED
Power on page 10-4.
Connecting the Dolphin Terminal to the Net Base
Yellow LED
DC Power Jack
on page 10-5.
10-3