Operation; Pressure Washer Location; Before Starting The Engine; Starting The Engine - Champion 76553 Owner's Manual And Operating Instructions

Operation

Pressure Washer Location

This pressure washer must have at least five
feet of clearance from combustible material.
Leave at least three feet of clearance on all
sides of the pressure washer to allow for
adequate cooling, maintenance and
servicing.
Place the pressure washer in a well-
ventilated area. DO NOT place the pressure
washer near vents or intakes where exhaust
fumes could be drawn into occupied or
confined spaces. Carefully consider wind
and air currents when positioning pressure
washer.

Before Starting the Engine

1. Turn the water ON.
2. Pull the trigger on the pressure gun to
purge all air from the pump and hose.
This may take several minutes.
3. Do not start the engine until a steady
stream of water is flowing from the
nozzle.

Starting the Engine

1. Make certain the pressure washer is on a
flat, level surface.
2. Rotate the fuel valve to the "ON"
position (to the left). See image below
3. Move the choke lever (Item A) to the
"Choke" position (to the left).
Rev 76553-20100203 - English
4. Pull the starter cord slowly until
resistance is felt and then pull rapidly.
5. As engine warms up, move the choke
lever to "Run" (to the right).
6. Move the throttle lever (Item B) to the
"Fast" position.
NOTE
If the engine does not start after 2 pulls, relieve
pump pressure by pulling the trigger on the
pressure washer gun.
NOTE
If the engine starts but does not run make
certain that the pressure washer is on a flat, level
surface. The engine is equipped with a low oil
sensor that will prevent the engine from running
when the oil level falls below a critical threshold.

High Pressure Wash

CAUTION
Always engage the trigger safety latch when the
unit is not in use.
The trigger safety latch prevents the gun from
being triggered accidentally. Push the latch fully
down to engage it.
Your unit is equipped with a quick connect
nozzle port. Choose the appropriate nozzle
tip for the job you are performing.
CAUTION
The narrow high impact spray can damage some
surfaces.
Operation
9