Connectors - Axis P1347–E User Manual

Hide thumbs Also See for P1347–E:

Table of Contents

AXIS P1347–E Network Camera

Hardware overview

15. Bracket screws (4x)

16. Bracket adapter

17. Network cable (route through wall bracket)

18. Wall bracket

19. Bracket adjustment screw

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).

Caution

Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded

network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar

shall be shielded (STP) and intended for their speciﬁc use. Make sure that the network switch is properly grounded. See

Electromagnetic Compatibility (EMC) for regulatory requirements.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker

with a built-in ampliﬁer. A stereo connector must be used for the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For

instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup

> System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•

Enabling the Focus Assistant. Press and very quickly release the Control button.

•

Connecting to an AXIS Video Hosting System service. See page 45. To connect, press and hold the button for about

1 second until the Status LED ﬂashes green.

•

Connecting to AXIS Internet Dynamic DNS Service. See page 45. To connect, press and hold the button for

about 3 seconds.

•

Resetting the product to factory default settings. See page 51.

Power connector - 2-pin terminal block for power input.

I/O connector

DC power input

Table of Contents