Advertisement
Section 3: Dispensing the Label
To dispense a label, first load label stock as described in Section 2, connect power and switch on
the Label Dispenser. Follow these steps to dispense labels.
1. Before you start dispensing you should adjust the Label Sensor on the Label Sensor Bracket
Figure 3-1.
2. To Start dispensing press the Start/Stop button on the Contr ol Panel. (Figure 3-2.)
Figure 3-2.
so that the distance between the Label Sensor and the Peel Edge is equal to r oughly 1/2"
less than the label height. (Figure 3-1.)
For example, for a 4" wide x 2" high (101.6mm x 50.8mm) label you would set this distance
to approximately 1-1/2" (38.1 mm). The exact distance is not critical. It is only important
that you set the distance so that the label does not come of f the liner when presented. If the
label height dictates the sensor be moved beyond the available travel, set the sensor to the
minimum or maximum position as applicable.
Start/
Counter
Stop
Reset
-
+
1/2" less than Label Height
DX850e Label Dispenser 9
Advertisement
