Advertisement
Section 1: Unpacking and Setup
Thank you for purchasing the DX850e Label Dispenser (hereafter referred to as "Label
Dispenser").
The Label Dispenser includes a Power Cor d, 12 volt Power Adapter and the parts shown in
Figure 1-1. The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along
with the Power Cord. You will need to assemble them as shown in Figure 1-1 and 1-2. Also see
Section 2 for more detailed instructions on assembling these parts. Attach the Power Cord
and switch on the power as shown in Figure 1-2. Finally, remove the foam insert between the
Liner Idler Roller and Liner Drive Roller.
Figure 1-1.
Liner Drive Roller
Liner Idler Roller
Liner Idler Roller Tab
Label Sensor Bracket
Figure 1-2.
Power Switch
Power Input 12V
Guide Roller
Label Sensor
Peel Edge
Power Adapter
Power Adapter
Power Cord
Roll Guides
Roll Bar
Control Panel
Roll Guides
Roll Bar
Roll Drag Arm
DX850e Label Dispenser 3
Advertisement
