Advertisement
4. Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either
side of the Roll Bar, but the rounded tip of the Roll Drag Arm should be located in the
center of the inside of the cor e. The arm is spring loaded so that ther e is downward
pressure on the inside of the r oll. This helps prevent application alignment problems
near the end of a roll. (Figure 2-3.)
Figure 2-3.
5. Place the removed Roll Guide back on the Roll Bar and slide it close to, but not touching the
label stock roll. (Figure 2-4.)
Figure 2-4.
Tip! Roll Guide Uprights
must not pinch the label
stock roll. (The label
stock roll must have free-
play between guides.)
DX850e Label Dispenser 5
Advertisement
