Advertisement
Notices: The information in this document is subject to change without notice. NO W ARRANTY OF ANY KIND IS MADE WITH REGARD
TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. No liability is assumed for err ors contained herein or for incidental or consequential damages in connectio n with the
furnishing, performance, or use of this material. This document contains pr oprietary information that is protected by copyright. All rights are
reserved. No part of this document may be photocopied, r eproduced, or translated into another language without prior written co nsent.
Trademark Acknowledgments: Windows is a registered trademark of Microsoft Corporation. All other trademarks are the property of their
respective owners.
Printing History
Edition 1.0, #201011, Copyright 2011, All rights reserved.
FCC Compliance Statement: This device complies with part 15 of the FCC r ules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interfer ence, and (2) this device must accept any interfer ence received, including interference that
may cause undesired operation.
For Users in the United States: This product is intended to be supplied by a UL listed Direct Plug-In Power Supply marked "Class 2" or a UL listed
ITE Power Supply marked "LPS" with output rated 12VDC, 4.5A or higher. This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. In a domestic envir onment this product may cause radio interference, in which case the
user may be required to take adequate measures. This equipment generates, uses, and can radiate radio fr equency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interfer ence to radio or television reception, which can be determined
by
turning the equipment off and on, the user is encouraged to try to corr ect the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and r eceiver.
Connect the equipment into an outlet on a cir cuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cables is required to comply with the Class A limits of Part 15 of the FCC Rules. You are cautioned that any changes or
modifications not expressly approved in this manual could void your authority to operate and/or obtain warranty service for thi s equipment.
For Users in Canada: This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the Radio Interfer ence
Regulations of the Canadian Department of Communications. Le pr esent appareil numerique n'emet pas de bruits radioelectriques depassant les
limites applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le br ouillage radioelectrique edicte par le ministere des
Communications du Canada.
General Safety Information.
Note: Notes are used to notify of installation,operation, or maintenance information that is important but not safety r elated.
Caution: Caution is used to indicate the pr esence of a hazard, which if ignored may result in damage to the unit.
Warning: Warning means that a potential safety hazard exists and indicates procedures that must be followed exactly to avoid serious per sonal injury.
!
WARNING!
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE EXTERIOR PANELS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL. OPERATE THE UNIT WITH ONLY THE PROPER ELECTRICAL SPECIFICATIONS AS LABELED
ON THE PRINTER AND AC ADAPTER.
!
WARNING!
DO NOT WEAR LOOSE FITTING CLOTHING SUCH AS NECK TIES OR LOOSE LONG SLEEVES WHEN OPERATING THE DX850. THE
MOTOR IS VERY POWERFUL AND THE LINER DRIVE ROLLER COULD CATCH THE CLOTHING WHILE THE LABELS ARE BEING
APPLIED.
Advertisement
