Table of Contents
Advertisement
Gas Conversion (continued)
32
Step 2: Changing the burner orifices
1 .
Replace the main burner orifices
a.
Remove the grates, flame tamers, and drip tray
from the grill. See figure below.
WIDTH
b.
Remove the locking pins from the end of the
burners.
The locking pins are accessible by removing the
drip tray and tilting the grill back. They can be
seen underneath the grill in the back. See figures
below.
c.
Remove all burners by carefully lifting them up
and away from the valve orifice.
www.calflamebbq.com
Burner
Locking Pin
You will need:
•
6mm socket or nut driver
•
Two to five 1.9mm orifices (depending on
your grill
•
Pipe compound suitable for natural gas
Orifice
d.
Using a 6mm socket or nut driver, remove the
orifice for the burner.
e.
Apply a small amount of pipe compound to the
orifice threads.
Burner
f.
Screw in the orifice until it is finger tight.
g.
Tighten the orifice with the 6mm wrench.
h.
Repeat the above steps for the remaining
Locking Pin
burners.
i.
Replace the burners, flame tamers, drip tray, and
grates.
You do not need to replace the locking pins. They
are used to keep the burners in place during
shipping and are not necessary to operate your
grill.
HEIGHT
Top Gun Barbecue Grill
LTR50001121, Rev. A
Advertisement
Table of Contents
