Table of Contents
Advertisement
26
4 .
Clean the grill interior
While the burners are out of the grill, you can use this opportunity to clean the interior of your grill
thoroughly. You should still have the drip pan in place to catch water and grime as you clean the grill
interior.
When the grill interior is clean, remove the drip pan. Dump out any water and grime residue and spray it
off with a garden hose.
Dry both the grill interior and the drip pan thoroughly to prevent water damage.
5 .
Clean the components
You can clean the racks by first soaking them in warm water and dish detergent and scrubbing them with
a wire brush.
Clean the flavor bars and the flame tamers with dish detergent. You can use any kind of scrubber you wish:
a non-abrasive pad, steel wool, or a wire brush, depending on your needs.
Dry all of the components thoroughly to prevent water damage.
6 .
Replace the burners
Before you replace the burners, inspect the gas
valve orifices for cleanliness and condition and
the location of the igniters.
Set the flame tamers in place before you replace
the burners.
Carefully insert the burner into the opening for
the valve orifice and gently slide it in. Then set
the other end of the burner down so the anchor
post rests in the hole.
When you replace the burners, you don't need
to replace the locking pins.
7 .
Replace the
components
Put all of the components
back as they were, as
shown in step 1.
www.calflamebbq.com
Top Gun Barbecue Grill
LTR50001121, Rev. A
Advertisement
Table of Contents
