Table of Contents
Advertisement
INSTALLATION AND OPERATION
If the optional large mounting base is ordered
(LPEDD option) it will be supplied with four 1/4-20 x
3/4 mounting screws. If the plate is factory installed
these screws will be used for that installation and
not supplied as loose parts.
2.4 Equipment Required but Not Supplied
Table 4 is a list of equipment that may required
to install and make use of the 3960. As a minimum
the 3960 requires a source of operating power, a
monitor on which to view the scene, an interconnec-
tion cable, and a computer running Graphical User
Interface (GUI) software for control of the 3960 if
this is desired. Programming the optional ID gen-
erator messages requires a GUI software such as
the Cohu WinMPC setup and maintenance soft-
ware. This is available at no cost from Cohu Elec-
tronics:
www.cohu-cameras.com
During maintenance and setup operations
using either a laptop or desktop PC it is likely that a
6X-1050a
Figure 8. Dimensions, Model 3960
422/232 converter will be required. Most PC's have
only a serial RS-232 communications port.
stainless steel (preferably grade 316) mounting
bolts and a platform of some type on which to
mount it. Gasket materials and sealing compounds
may also be required to provide waterproofing of
mounting holes in structures.
a tensioning tool is available to snug up the stain-
less steel straps holding the mount to the pole.
2.5 Cabling Requirements
through a permanently attached 34-inch cable. This
cable is attached to the bottom of the 3960 housing.
A 16 pin connector is attached to the free-hanging
end of the cable.
system interconnections. This connector should not
be attached to the system cable until it is known that
Installing the 3960 will also require high quality
For installing with a pole mount (POLE option),
All electrical connections for the 3960 route
A mating connector is supplied for making
3960 CAMERA
9
Advertisement
Table of Contents
