Table of Contents
Advertisement
3960 CAMERA
1. Verify that the system cable has been properly
routed to a location where the corner-mount bracket
will be attached. Plan the routing before doing any
installation.
2. Attach the connector to the system cable (if not
already installed).
3. Fasten the corner mount bracket to the structure –
being sure that the system cable is routed so that it is
available for the wall-mount arm.
4. Attach the adapter plate to the wall mount arm (if
not already attached).
5. Route the 3960 pigtail cable down into the arm
and out the hole at the bottom near the back. Note
that plastic plugs can be removed to aid in this
process.
6. Position the 3960 on the arm adapter plate and
secure it with the hardware.
7. Connect the pigtail connector to the system cable
connector.
8. Pull the system cable back so the arm can be slid
over the corner mount threaded studs..
9. Install lock washers and nuts to secure the arm to
the bracket..
10. Verify that the 3960 will have a full range of
movement without striking any nearby structures.
11. Refer to section 3 to set up and check out the
3960.
4.6 PARAPET MOUNT INSTALLATION
Figure 7 shows the parapet mount. A parapet
is the wall that rises above the flat roof of a typical
commercial building. This mount typically attaches
inside this raised wall and the vertical mounting
surface faces out toward the surrounding area. The
wall mount arm bolts directly to the parapet mount.
Figure 26 shows a parapet mount installed on
the roof of a building. Dimensions are shown in
figure 25.
26
INSTALLATION AND OPERATION
Figure 24. Dimensions, Corner Mount
1. Verify that the system cable has been properly
routed to a location where the parapet-mount bracket
will be attached. Plan the routing before doing any
installation.
2. Attach the connector to the system cable (if not
already installed).
3. Fasten the parapet mount bracket to the structure
– being sure that the system cable is routed so that it
is available for the wall-mount arm.
4. Attach the adapter plate to the wall mount arm (if
not already attached).
5. Route the 3960 pigtail cable down into the arm
and out the back. Note that plastic plugs can be
removed to aid in this process.
6. Position the 3960 on the arm adapter plate and
secure it with the hardware.
7. Connect the pigtail connector to the system cable
connector.
6X-1050a
Advertisement
Table of Contents
