Table of Contents
Advertisement
INSTALLATION AND OPERATION
1. Verify that the system cable has been properly
routed to a location where the pole-mount bracket will
be attached. Plan the routing before doing any
installation.
2. Attach the connector to the system cable (if not
already installed).
3. Fasten the pole-mount bracket to the pole – being
sure that the system cable is routed so that it is
available for the wall-mount arm.
4. Attach the adapter plate to the wall mount arm (if
not already attached).
5. Route the 3960 pigtail cable down into the arm
and out the back. Note that plastic plugs can be
removed to aid in this process.
6. Position the 3960 on the arm adapter plate and
secure it with the hardware.
7. Connect the pigtail connector to the system cable
connector.
6X-1050a
Figure 23. Dimensions, Pole Mount
8. Pull the system cable back so the arm can be slid
over the pole mount threaded studs..
9. Install lock washers and nuts to secure the arm to
the bracket..
10. Verify that the 3960 will have a full range of
movement without striking any nearby structures.
11. Refer to section 3 to set up and check out the
3960.
4.5 CORNER MOUNT INSTALLATION
Figure 6 shows the corner mount bracket.. A
corner mount attaches to the corner of a building or
other structure to provide viewing on two sides of
the structure. The wall mount arm attached directly
to the corner mount. Figure 27 shows dimensions of
the corner mount assembly.
A corner mount installation is similar to the wall
mount installation except that the arm fastens to a
pole mount bracket instead of directly to a wall.
3960 CAMERA
25
Advertisement
Table of Contents
