Samsung BACnet MIM-B17N User Manual page 24

10
Select MDS setting .
You can set MDS(Motion Detection Sensor) through button activation / non
activation.
Set cooling/heating discharge temperature by clicking [ ] and [ ].
11
When the indoor unit is in Cool mode, you can adjust cooling discharge temperature
and when the indoor unit is in Heat mode, you can adjust the heating discharge
temperature.
When the indoor unit is in Auto, Dry or Fan mode, you cannot adjust the discharged
temperature.
Cooling discharged temperature can be set in the range of 8°C(46°F)~18°C(64°F).
Heating discharged temperature can be set in the range of 30°C(68°F)~43°C(109°F).
Select [Control Discharge Temp].
12
You can enable/disable button to decide whether to use discharge temperature
adjustment.
Note When filter warning sign is displayed on indoor unit status window
Select the indoor unit and click [Reset filter].
Filter warning will be released.
Make sure that each indoor unit must be turned on to control.
Selecting remote controller, reset filter, operation mode limits, setting lower/upper
temperature limit are possible even if the power of indoor unit is off.
Some air flow direction option may be restricted depending on the indoor unit
model.
SPI, MDS and discharge temperature functions can be operated normally when
corresponding optional functions are installed to the selected indoor unit.
23
E-