Fujitsu SK-96380-120PMC User Manual page 9

SK-96380-120PMC User Guide
Chapter 1 Overview
1.3.8 I2C Bus
Additional 10 kOhm pull-up resistors can be connected to the I²C bus lines by setting the
according jumpers. JP9 is for SDA0 and JP10 for SCL0.
1.3.9 Emulator System
If the board is used as an emulator target board, the microcontroller must be removed from
the socket and the corresponding probe cable has to be mounted:
Series V-Chip Probe cable Socket
MB2198-16FX-120P-M21
MB96380 MB96V300B NQPACK120SD, HQPACK120SD
Table 1-1: Emulation System
© Fujitsu Microelectronics Europe GmbH - 9 - UG-960019-11