Table of Contents
Advertisement
3.9.2 LIN-UART 2 (JP: 36, 37, 38, 39, 40, 42, 43, 45)
Jumper
JP37
(RXD)
JP39
(TXD)
JP40
(RS232/LIN)
JP36
(RTS-CTS)
JP38
(DTR/RTS)
JP43
(LIN enable)
JP45
(LIN master)
JP42
(LIN Vbat)
3.10 CAN interfaces (JP: 24, 26, 34, 35)
Two high-speed CAN-transceivers can be connected to the microcontroller's CAN interfaces
(CAN0 and CAN1).
Jumper
JP24
(CAN0 RX)
JP26
(CAN0 TX)
JP34
(CAN1 RX)
JP35
(CAN1 TX)
© Fujitsu Microelectronics Europe GmbH
SK-96380-120PMC User Guide
Chapter 3 Jumpers and Switches
Setting
Description
1-2
SIN2 is connected to RS232 transceiver
2-3
SIN2 is connected to LIN transceiver
1-2
SOT2 is connected to RS232 transceiver
2-3
SOT2 is connected to LIN transceiver
1-2
X9 pin 2 is connected to RS232 transceiver
2-3
X9 pin 2 is connected to LIN transceiver
Closed
RTS and CTS of X9 are connected
Open
RTS and CTS of X9 are not connected
1-2
DTR signal (pin 6 of X9) is used as reset source
2-3
RTS signal (pin 7 of X9) is used as reset source
Closed
LIN transceiver for X5 is enabled
Open
LIN transceiver for X5 is disabled
Closed
LIN-UART2 is LIN Master
Open
LIN-UART2 is LIN Slave
Closed
LIN bus (X9 pin 1) is powered by the board
Open
LIN bus (X9 pin 1) is not powered by the board
Table 3-8: UART2 Settings
Setting
Description
Closed
RX0 is connected to CAN0 (X6)
Closed
TX0 is connected to CAN0 (X6)
Closed
RX1 is connected to CAN1 (X8)
Closed
TX1 is connected to CAN1 (X8)
Table 3-9: CAN Settings
- 21 -
UG-960019-11
Advertisement
Table of Contents
