Amana MV-194S Owner's Manual page 21

STEP 6: ATTACH THE OVEN TO THE WALL
6. Roof venting installation: Install ductwork through the vent
opening in the upper cabinet. Complete the venting system
through the roof according to the method needed.
See Figure 34. See PREPARE THE VENTING SYSTEM,
STEP 2. Use caulking gun to seal the exterior roof opening
around the exhaust cap.
See Figure 6.
7. Use the power supply cord clamp to bundle the power supply
cord. Install the power supply cord clamp, using a screw as
shown in Figure 34, to inside of the cabinet.
8. Grasp filter screen with one hand holding the ring and the other
hand holding the opposite end. Insert the end of the filter screen
without ring into the opening and slide towards the side of the
microwave oven. Insert ring end of filter screen into the opening
and slide entire screen towards the center of the microwave
until screen is securely in position. Repeat for other filter screen.
See Figure 35.
9. Plug in the power supply cord.
10. Read your Owner's Manual, then check the operation of your
microwave oven.
INSTALLATION
- 21 -
damper
Figure 33
duct
Figure 34
Figure 35
power
supply
cord
clamp