Metrologic MS2321 Installation And User Manual page 25

I
NSTALLATION
C I (I
ABLE NSTALLATION
F S USB
ULL PEED
Step 8 is for USB Serial Emulation Mode or Keyboard Emulation Mode only.
8. Configure the StratosH for USB Serial Emulation Mode or USB Keyboard Emulation Mode by scanning the
appropriate configuration bar codes in the USB section of the MetroSelect Configuration Guide (
under Low Speed USB. Any low speed USB warnings may be disregarded when utilizing these codes for a
Full Speed USB StratosH scanner.
Step 7 must be completed before continuing to step 8 for these features to work properly.
xxx*
Caution: To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for SELV
(Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm EN/IEC 60950, the power source should
meet applicable performance requirements for a limited power source.
S )
NTERFACE PECIFIC
Specifies international connection. See Optional Accessories in the Introduction section
of this guide for a complete listing.
Figure 23. USB Cable Installation Schematic
00-02407x)
MLPN
21