Section 7 - Adjustments Guide; Agitation Timer Adjustment - Manitowoc QPA-310 Installation, Use, Care, And Service Manual

Section 7
The agitation timer is standard equipment for the
floor standing dispenser. The purpose of the timer
is to periodically agitate the ice in the bin,
preventing the ice from congealing together.
The timer is located in the electrical box of the
dispenser. The two dials on the timer should be set
to agitate the ice for two second every four hours of
non-use of the ice dispenser.
To check the agitation timer,
use the following procedure:
1. Place a small screwdriver in the adjustment dial
marked "OFF TIME" (see illustration at right).
2. Gently turn the adjustment dial counter
clockwise until the dial stops. You will be
turning the dial so it points to the "O-MIN"
position.
3. Do not use the dispenser for 15 minutes. Within
that time period, the agitator will turn. If the
agitator does not turn replace the timer.
To reset the agitation timer,
Use the following procedure:
1. With a small screwdriver, gently turn both dials
counterclockwise until they stop. You will be
turning the dial so it pints to the "O-MIN"
position, which stands for O-minimum.
2. Turn the "ON TIME" (left dial) from the "0" to
the "2", for two seconds of agitation.
3. Turn the "OFF TIME (right dial) from the "0"
to the "4", so agitation will begin approximately
every four hours.
The drawing shows the position of the dials when
the timer is set correctly.

Agitation Timer Adjustment

Male slide
terminals
Adjustments Guide
The agitation timer is located in the
electrical box at the front of the dispenser.
ON TIME
Seconds of agitation
adjustment dial
Male slide
terminals
NOTE: Dials on actual agitation timer are not
marked with numbers, only small notches
OFF TIME
Hours off between
agitation
adjustment dial
Male
slide
terminals
Screw attaching
timer to dispenser
.
7-1