Section 6 - Ice Dispensing Troubleshooting - Manitowoc QPA-310 Installation, Use, Care, And Service Manual

Section 6
Unplug unit before servicing or cleaning.
Ice dispenser bin contains parts that can move at any
time and will cause injury if hands are in
the way.
Problem: Dispenser does not dispense ice
Problem
There is no power to the
dispenser.
There is power to the
dispenser, however nothing
runs.
Ice Dispensing Troubleshooting
WARNING
Possible Cause
Is the dispenser plugged in?
The dispenser is plugged in with
power to the receptacle. With a
meter, check to see if power is getting
to the white and black cord wires
inside the electric box.
Is power able to conduct through the
microswitch? With the dispenser
unplugged and the ohm meter probes
on the "C" and "NC" terminals,
depress the microswitch lever. The
mere reading should display ohms.
Release the microswitch lever. The
ohm value should register continuity.
If the gearmotor attempts to start but
fails to do so, check the capacitor.
Use a capacitor checker according to
the instructions supplied.
If gearmotor fails to attempt to start,
check the gearmotor. First,
disconnect power from the dispenser.
Then disconnect the gearmotor wires
in the junction box. Check for
continuity through the gearmotor.
Ice Dispensing Troubleshooting
Unplug unit before servicing or cleaning.
Electric Shock Hazard.
Plug the dispenser in.
If no power is present, check the
cord and plug of the dispenser,
Replace cord set if wire is broken.
Check continuity at the microswitch,
replace the switch or repair the
connection if defective.
If the capacitor does not test
correctly, replace the capacitor.
If gearmotor does not test correctly,
replace the gearmotor.
WARNING
To Correct
6-1