Table of Contents
Advertisement
INSTALLATION
12
A qualified service person must install heater. Follow all local codes.
CHECK GAS TYPE
Use only natural gas. If your gas supply is not natural gas, do not install heater. Call
dealer where you bought heater for proper type heater.
INSTALLATION ITEMS
Before installing heater, make sure you have the items listed below.
• piping (check local codes)
• sealant (resistant to propane/LP
gas)
• manual shutoff valve *
* An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable
alternative to test gauge connection. Purchase the optional A.G.A. design-certified
manual shutoff valve from your dealer. See Accessories, page 34.
LOCATING HEATER
Maintain the minimum clearances shown in Figure 10 (page 13). If
you can, provide greater clearances from floor, ceiling, and join-
ing wall.
You can locate heater on floor. The optional hearth base is needed. You can also
install the optional decorative mantel on the heater when using the optional hearth
base.
Only use optional mantel and hearth base specified in this
IMPORTANT:
manual. Purchase the optional mantel and hearth base from your dealer. See
Accessories, pages 34 and 35.
The heater may also be mounted on a wall. You cannot use optional mantel if
mounting heater on a wall.
Never install the heater
• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture, clothing, or other flammable objects are
less than 36 inches from the front, top, or sides of the heater
• as a fireplace insert
• in high traffic areas
• in windy or drafty areas
This heater creates warm air currents. These currents move heat
to wall surfaces next to heater. Installing heater next to vinyl or
cloth wall coverings or operating heater where impurities in the air
(such as tobacco smoke) exist, may discolor walls.
Vent-free heaters add moisture to the air. Although this is beneficial, in-
IMPORTANT:
stalling heater in rooms without enough ventilation air may cause mildew to form from
too much moisture. See Air for Combustion and Ventilation, pages 8 through 11.
NOTICE
• ground joint union
• test gauge connection *
(see Figure 24, page 21)
• sediment trap
WARNING
WARNING ICON
G 001
WARNING
WARNING ICON
G 001
CAUTION
WARNING ICON
G 001
• tee joint
• pipe wrench
101934
Advertisement
Table of Contents
