Table of Contents
Advertisement
OPERATING
HEATER
Continued
24
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas, STOP! Follow "B" in the safety information
at the top of page 23. If you don't smell gas, go to the next step.
5. Turn control knob counterclockwise
in control knob for five (5) seconds (see Figure 27, page 23).
You may be running this heater for the first time after hooking up
Note:
to gas supply. If so, the control knob may need to be pressed in for 30
seconds. This will allow air to bleed from the gas system.
6. With control knob pressed in, push down and release ignitor button. This
will light pilot. The pilot is attached to the front of burner. If needed, keep
pressing ignitor button until pilot lights.
If pilot does not stay lit, refer to Troubleshooting, pages 28 through
Note:
31. Also contact a qualified service person or gas supplier for repairs.
Until repairs are made, light pilot with match. To light pilot with match,
see Manual Lighting Procedure, page 25.
7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob.
• If control knob does not pop up when released, contact a qualified
service person or gas supplier for repairs.
Thermocouple
If pilot goes out, repeat steps 3 through 7. This heater has a safety inter-
Note:
lock system. Wait one (1) minute before lighting pilot again.
8. Turn control knob counterclockwise
main burner should light. Set control knob to any heat level between HI
and LO.
Do not try to adjust heating levels by using the manual shutoff valve.
to the PILOT position. Press
C-clockwise
Ignitor Electrode
Figure 28 - Pilot
to desired heating level. The
C-clockwise
CAUTION
WARNING ICON
G 001
Pilot Burner
101934
Advertisement
Table of Contents
