Table of Contents
Advertisement
How to Wire Your Ceiling Fan (cont'd)
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire.
operate fan until all parts are assembled. Noise and
fan damage could result.
3. Screw in two threaded rods into the Hanger Bracket
(Fig. 10a).
NOTE: The threaded rods in the hanger bracket serves
as guides for easier installation.
4. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled
knobs supplied with your fan (Fig. 10b).
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and
the ceiling.
5. Push the Motor Coupling cover down until it touches
the top of the Yoke Assembly (Fig. 10c).
6. Your Ceiling Fan is now ready for use.
1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Check the operation of the fan by turning the speed
control to "high".
3. Your fan model is equipped with a 4-position, 3-speed
control. The operating sequence is as follows:
1
position - OFF
st
2
position - HIGH
nd
3
position - MEDIUM
rd
4
position - LOW
th
4. Wall Control (CH1) and Remote Control (CH4) are
available as an accessory — contact your local dealer
for ordering information.
Do not
Operating the Ceiling Fan
Fig. 10a
Speed Control
NOTE: If using the Wall Control (CH1) or the
Remote Control (CH4), the 4-position fan speed
control MUST be set on HIGH.
7
Fig. 10b
Fig. 10c
Fig. 11
Advertisement
Table of Contents
