Disc Selection - Makita DPV300 Instruction Manual

Installing backing pad
CAUTION:
Make sure that the backing pad is
secured properly. Loose attachment will run out of balance and
cause an excessive vibration which may cause loss of control.
CAUTION:
Never actuate the shaft lock when
the spindle is moving. The tool may be damaged.
NOTE: Regularly clean the accessories and spindle
to remove dust and debris. Wipe the components
clean with a cloth dampened in soapy water if
necessary.
Hook-and-loop system
Press in the shaft lock to prevent spindle rotation, and thread
the backing pad into the spindle. Hand tighten securely.
3
2
1
► 1 . Shaft lock 2. Spindle 3. Backing pad
To remove the backing pad, follow the installation pro-
cedure in reverse.
Twist-on/twist-off system
Screw the backing pad onto the adapter. Then thread
the other end of the adapter into the spindle while
pressing in the shaft lock. Hand tighten securely.
1
2
► 1 . Backing pad 2. Adapter 3. Shaft lock 4. Spindle
4
3
To remove the backing pad, follow the installation pro-
cedure in reverse.
Installing and removing
polishing pad
CAUTION:
Only use the hook-and-loop sys-
tem pads for polishing.
CAUTION:
Make sure that the pad and
backing pad are aligned and securely attached.
Otherwise the pad will cause an excessive vibration
which may cause loss of control or the pad may be
thrown out from the tool.
Remove all dirt and foreign matter from the hook-and-
loop system of a pad and backing pad. Attach the pad to
the backing pad so that their edges are aligned.
To remove the pad from the backing pad, just pull up
from its edge.
1
2
► 1 . Pad 2. Backing pad
Installing abrasive disc
Optional accessory
CAUTION:
Only use the twist-on/twist-off
system discs for sanding.

Disc selection

CAUTION:
The outside diameter of accessory
must be within the capacity rating of the power
tool.
CAUTION:
The rated speed of accessory
must be equal or higher than the maximum speed
marked on the power tool.
Always use the correct sized wheel that is made from
appropriate abrasive materials with the right grit size for
your job.
10 ENGLISH