Installing Abrasive Disc - Makita DBO180 Instruction Manual

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Switch action and speed adjusting
button
2
► 1 . Stop button 2. Start/speed adjusting button
To start the tool, press the start/speed adjusting button.
The tool starts with high speed mode. Each time you press
the start/speed adjusting button, the speed mode changes
in an order of hi speed, middle speed, and low speed.
To stop the tool, press the stop button.
Refer to the table for the relationship between the
speed mode and the kind of work.
Speed mode Number of rotations
High
Middle
Low
NOTE:
• The table shows standard applications. They
may differ under certain conditions.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1
Usage
Regular
11,000
sanding
Finish
9,500
sanding
7,000 Polishing
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.

Installing abrasive disc

1
► 1 . Pad 2. Abrasive disc
To install the abrasive disc, first remove all dirt or for-
eign matter from the pad. Then attach the abrasive disc
to the pad. Be careful to align the holes in the abrasive
disc with those in the pad.
Installing dust bag (optional
accessory)
► 1 . Dust bag
Install the dust bag on the tool with its mouth directing
downwards.
6 ENGLISH
2
1