Installing The Canopy Housing; Final Assembly - Options - Fanimation Enigma FP2120 Series Owner's Manual

NOTE: This step is applicable after the neccessary
wiring is completed. (see page 7)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
NOTE: The threaded rods in the hanger bracket serves
as guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled
knobs supplied with your fan (Figure 1b)
Light Bulb Option:
CAUTION
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before installing light
bulb.
▲WARNING
To prevent over-heating or electrical fi res, use ONLY
PAR30, short-neck halogen bulb, 75 watt max, as
specifi ed (bulb not included).
1. Carefully screw the bulb in the socket fi rmly.
2. Restore power.
Lower Cap Option:
▲WARNING
Do NOT install lower cap while the ceiling fan is on!
1. To install lower cap - screw in lower cap into bulb
socket until tight. (Figure 3)
3. Restore power.

Installing the Canopy Housing

Final Assembly - Options

NOTE: Supply wires and fan wires omitted for clarity
Figure 1a
8
Figure 1b
Figure 1
Figure 2