Bosch HBL8750 Use And Care Manual page 50

Service
Before Calling Service
Troubleshooting Chart
Oven Problem
Oven door is locked and will not open,
even after cooling.
Oven is not heating.
Oven is not cooking evenly.
Baking results are not as expected.
Food takes longer to cook than expected.
Food is overcooked.
Convection Bake/True Convection results
are not as expected.
Oven light is not working properly.
Oven light does not turn off.
Oven is not self-cleaning properly.
Clock and timer are not working properly.
" E" and a number appears in display and
control beeps.
With a new oven there is a strong odor
when oven is turned on.
Control does not react when a key is
touched.
Fan is running during modes that do not
use convection
English 47
All manuals and user guides at all-guides.com
Possible Causes and Suggested Solutions
Turn the oven off at the circuit breaker and wait five m inutes. Turn breaker
back on. The oven should re set itself and will be operable.
Check circuit breaker or fuse box to yo ur house. Make sure there is proper
electrical power to the oven. Be su re oven temperature has been selected.
Refer to cooking charts for reco mmended rack position. Check " Getting the
Most Out of Your Appliance" for tips and suggestions.
Refer to cooking char ts for recommended rack position. Check " Getting the
Most Out of Your Appliance" for tips and suggestions. Adjust oven
calibration if necessary. See " Oven Temperature Offset " under " Setup ".
The oven is carefully ca
temperature can be offset if food is co nsistently too brown or too light. See
" Oven Temperature Offset " under " Setup ".
The oven is carefully calibrated to provide
temperature can be offset if food is co nsistently too brown or too light. See
" Oven Temperature Offset " under " Setup ".
The oven temperature must be manually reduced by 25 ºF, u nless
Automatic Convection Conversion is ac tivated. Refer to cooking charts and
tips for rack positions, cooking ti mes and pan selection. Adjust oven
calibration if necessary. See " Oven Temperature Offset " under " Setup ".
Replace or reinsert the light bulb if loose or defective. Touching the bulb
with fingers may cause the bulb to burn out.
Check for obstruction in oven door. Check to see if hinge is bent.
Allow the oven to co ol before running self-cle an. Always wipe out loose
soils or heavy spillovers before runnin g self-clean. If oven is badly soiled,
set oven for the maximum self-clean time.
Make sure there is e lectrical power to oven.
This is a fault code. Follow th e instructions in the display.
If the code remains or there are no instructions in the di splay, press INFO
to display more information (if applicable) and to turn off the beep.
If the code is still displa yed, write down the fault code number, turn off the
oven, and call Service.
This is normal with a new oven an d will disappear after a few uses.
Operating the self-clean cycle also "burns-off" the smell more quickly.
Be sure that surface is clean and dry. Touch the center of
Use the flat part of your finger.
On some models, the convection fan runs while the oven is pr
This is normal.
librated to provide accurate results. However, the
accurate results. However, the
the touch key.
eheating.