Installation Instructions; Water Supply Connections; Water Outlet Hose Connection - Zanussi ZT 6910 Instruction Book

Installation instructions

Remove all packaging before positioning the
machine.
If possible, position the machine next to a water tap
and a drain.

Water supply connections

This dishwasher must be plumbed into a cold water
supply.
The water pressure must be within the limits given in
the technical specifications.
Your local Water Authority will advise you on the
average mains pressure in your area.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation.
Do not use, for the connection, old hoses which
have been used in another appliance.
The locknut must be correctly fitted to avoid
water leaks.
Avoid bends or kinks in the hose which could
prevent or slow down the water supply.
If the machine is connected to new pipes or pipes
which have not been used for a long time, you
should run the water for a few minutes before
connecting the inlet hose. This will prevent deposits
of sand or rust clogging the inlet hose filter.

Water outlet hose connection

The end of the drain hose can be connected in the
following ways:
1. To the sink outlet siphon, securing it if necessary
with a clip.
2. To a stand pipe provided with vent-hole, minimum
internal diameter 4 cm.
The waste connection must be at a height of
between 30 cm (minimum) and 100 cm (maximum)
from the bottom of the dishwasher.
The drain hose can face either to the right or left of
the dishwasher
Ensure the hose is not bent or squashed as this
could prevent or slow down the discharge of water.
The sink plug must not be in place when the
machine is draining as this could cause the
water to siphon back into the machine.
All manuals and user guides at all-guides.com
22
Any electrical work required to install
this appliance should be carried out by a
qualified electrician or competent
person.
Any plumbing work required to install
this appliance should be carried out by a
qualified plumber or competent person.
Attention!
Our appliances are supplied with a
security device to protect against the
return of dirty water back into the
machine.
If the spigot of your sink has a "no return
valve" incorporated this can prevent the
correct draining of your dishwasher.
We advise you therefore to remove it.
1
CS13
CS14
2
+ 2 m max