Carrier XCT 7 40VK005-030S-7S-QEE Installation And Owner's Manual page 19

Installation Procedures
Installing and Dismantling the Indoor Unit
1. Installation
While installing this series of machines, fasten the wall pad on the wall first; hang the machine on the pothook; push it
towards the wall pad until the sound of 'pa' 'pa' is heard. At this time, the agraffes of the indoor unit have hitched onto
the pad, as shown in Fig. 1 with dotted lines.
2. Dismantling
While dismantling this series of machines, push agraffes from the bottom of indoor unit upward to release them, as
shown in Fig. 3, and pull the bottom of the indoor unit outwards gently and then raise the unit upwards in the bevel
direction to release the pothook at the upper part of the wall pad, as shown in Fig. 3.
agraffe
Wall pad
Fig. 3
Wall pad
agraffe
12
Fig. 1
Fig. 2
Fig. 4