JVC RX-ES1SL Service Manual page 5

3.1 Main body section
3.1.1 Removing the top cover
(See Figs.1 and 2)
(1) From the back side of the main body, remove the three
screws A attaching the top cover.(See Fig.1)
(2) From the both sides of the main body, remove the four
screws B attaching the top cover.(See Fig.1)
(3) Release the six joints a using a longer driver from the
inside.(See Fig.2)
Note:
• Do not damage any part and board inside the main
body when releasing the joints a using a longer driver.
(4) Remove the top cover while lifting the top cover in direction
of the arrow. (See Fig.1)
3.1.2 Removing the front panel assembly
(See Figs.2 to 4)
• Prior to perform the following procedure, remove the top cover.
(1) From the top side of the main body, cut the tie bands and
disconnect the wire from the connector
board. (See Fig.2)
(2) From the bottom side of the main body, remove the four
screws C attaching the front panelassembly. (See Fig.3)
(3) From the both sides of the main body, release the joints b
and remove the front panelassembly in the direction of the
arrow. (See Fig.4)
(4) From the top side of the main body, remove the screw D
attaching the earth wire on the DC power board. (See
Fig.2)
References:
• After attaching the front panel assembly, bundling the wires
using the new tie bands.
• When attaching the screw D, attach the earth wire with it.
SECTION 3
DISASSEMBLY
A
CN451 on the main
Main board
Front panel assembly
Top cover
Fig.1
Joints a
Tie bands
CN451
Fig.2
Front panel assembly
Fig.3
Joint b
Fig.4
B B
x2 x2
Front panel assembly
Earth wire
D
DC power
board
C
(No.MB105)1-5