Table of Contents
Advertisement
Using the optical slave feature, the VS-510S can be set to fire whenever it detects a signal from the master
flash. This works optically—when the VS-510S "sees" another flash firing, it will instantaneously fire along
with it.
Setting the remote flash units manually: To set a VS-510S flash unit to function as a slave with the output
level selected manually, follow these steps:
1.
Make sure that the slave mode switch is set to the Off position.
2.
Press the Mode button repeatedly to cycle through the mode options on the LCD. Select manual mode and
the desired flash output level (1/1 through 1/32).
3.
If desired, adjust the flash coverage angle by pressing the Zoom button repeatedly.
4.
Move the slave mode switch to the "S" position.
5.
Set the slave mode as desired (see below).
6.
Make sure that the master flash on your camera is on and set to the appropriate mode. If you don't want
the master flash to illuminate a subject in front of the camera, tilt the head upward.
Using Your VS-510S as a Wireless Manual Flash
|
33
Advertisement
Table of Contents
