Table of Contents
Advertisement
1.
When you turn the flash on, it will be in automatic mode. This will be confirmed by the TTL mode indicator
on the LCD. If the flash has been set to another mode, press the Mode button repeatedly to cycle through
the flash modes until "TTL" is shown on the LCD.
2.
Make sure your camera is set on a programmed or automatic mode, or on a priority mode such as
aperture-priority.
3.
Press the shutter-release button on your camera halfway to ensure that the camera is communicating
with the flash. The camera's ISO and aperture settings will be displayed on the flash LCD, and a flash icon
will appear in the camera's viewfinder.
4.
Make sure that your subject is not farther away than the suggested maximum flash-to-subject distance
indicated on the flash LCD.
5.
Press your camera's shutter-release button to take the picture. The OK indicator will flash on the VS-
510S's LCD, and the OK light below it will glow green momentarily to indicate that the proper exposure
was attained.
Note: The ISO and aperture indicators on the VS-510S provide readouts up to ISO 800 and f/11, in full-stop
increments. The indicator will display the ISO number and f-stop closest to your current camera settings.
|
18
Using the Automatic TTL Flash Mode
Advertisement
Table of Contents
