Creating A Single-Server Installation - Extreme Networks AG200 Installation Manual

Installing Sentriant AG
To find the current Default Gateway:
Linux – Enter
Windows - Enter
NOTE
Your system may require a different gateway. Check with your network administrator if you have problems or are
unsure of which gateway IP address to use.
Primary nameserver IP address (DNS server)—The IP address of the server that you use to convert
●
hostnames to IP addresses. For example: 204.74.112.1.
To find the current DNS server:
Linux – Look in the
Windows – Enter
If you use secondary and tertiary nameservers, you will be asked for those IP addresses as well.
Sentriant AG hostname —The names you give your Sentriant AG servers (MS and ESs). Select names that
●
are short, easy to remember, have no spaces or underscores, and the first and last character cannot be a dash (-
).
NOTE
The Sentriant AG hostnames must be the fully qualified domain names (FQDN). The FQDN includes the host and
the domain name—including the top-level domain. For example, waldo.mycompany.com.
Time zone—The time zones where your Sentriant AG servers are located. The time zones must be specified
●
for each MS and each ES.
Sentriant AG server root password—The passwords you give to your Sentriant AG servers (MS and ESs)
●
when logging in as the
Database password—The passwords you give to your Sentriant AG databases. There is a database on the MS,
●
and one on each ES. If you have a single-server installation, there are two databases on this one server and this
password is used for both of them.
Installation type—The type is either MS or ES for multiple-server installations, or Both for single-server
●
installations.
NTP server IP—The IP address you use for your Network Time Protocol (NTP) server
●
Enforcement cluster name—The logical groupings that you use with ESs. Each ES is joined to an
●
Enforcement cluster.

Creating a Single-server Installation

To install the MS and ES on a single server:
1 Locate the server you are using for the Sentriant AG installation.
2 Insert the Sentriant AG CD into the dedicated server and reboot (for example by pressing [Ctrl]+[Alt]+[Delete]
or an appropriate method of reboot). Once the server reboots, the boot prompt screen appears
42
at the command line
route -n
at the command line
ipconfig
/etc/resolv.conf
at the command line
ipconfig /all
user. Note: This is not the Sentriant AG user interface administrator password.
root
file for the entry.
nameserver
(Figure
Sentriant AG Installation Guide, Version 5.0
16).