Unit Parts Identification - koppel KWR-12M4A2 Owner's Manual & Installation Manual

UNIT PARTS IDENTIFICATION

NOTE: Different models have different front panels and cabinets.
explanatory purposes. The actual shape of your indoor unit may be slightly different. The actual
shape shall prevail. See the following figures for references:
3
1
2
1. Front panel
2. Air filter
3. Frame
4. Cabinet
Accessories
Seal( ) Drain Joint(
(Used on
drain joint)
1 pc 1 pc
[ ] Model dependent
Vent Control
The vent control is located above the control knobs. The operation method and the shape may vary
in different models (see the following figures)
For maximum cooling efficiency, CLOSE the vent. It will allow internal air circulation. OPEN the vent to
discharge stale air.
CLOSE VENT
NOTE: The vent control is not available for all the units. Some units do not have vent control.
4
5
6
7
8
5. Air inlet grille(outdoor side)
6. Air outlet grille
7. Operation knob
8. Power supply cord
9. Control panel cover(some units)
)
Drain pan( )
or
(depending on
1 pc
models)
OPEN
Illustrations in this manual are for
3
2
1
Screw
Rubber Plug
2 pcs(For some units, used)
1~2 pc
to fasten the front panel)
2 pcs or 4 pcs(used to install
the drain pan)
CLOSE
4
5
6
7
8
9
PVC sheath and
cable ties(
1 pc 4 pcs
OPEN
Page 13

)
