Advertisement
SITE & POOL DECK REQUIREMENTS
This lift is designed for commercial or residential use on in ground pools and spas. This lift is
not designed to clear a wall or obstacle. The lift should be installed on the pool deck where a
straight linear section of the pool wall is at least six (6) feet long. The lift should be installed at a
pool depth (pool deck to pool floor) of no less than 42" but not more than 48 inches. If the edge
of the pool deck curves the anchor system will need to be anchored differently than what these
instructions outline; contact Pentair Commercial Aquatics™ for assistance in this case. The
front anchors of the lift need to be mounted a minimum of 14 inches and no further than 19
inches from the inside pool wall. If your pool or spa has hand rails or other extensions on the
inside of the pool wall, the set back distance must take these into account. Contact Pentair
Commercial Aquatics for assistance in these types of applications.
In order to properly install this anchor system into an existing pool deck, your pool deck MUST
be at least 3'-3" long, by 3'-3" wide and 10 inches thick. It must also be reinforced with #4 rebar
on 10 inch centers in both directions. There may be instances where your existing pool deck
may not be structurally sound enough or does not meet the minimum requirements outlined
above for the safe installation of this anchor system. In those circumstances it is recommended
that you follow the Saw Cutting Retro-fit Instructions on page 6. If you are installing this lift in a
new application where the pool deck has not been poured yet, then go to the New Construction
instructions on page 7.
FIGURE 1
4
Advertisement
