Advertisement
If the battery is fully charged and the AquaTRAM
Access Lift is not moving then:
2. Check all cords:
A. Check that the cords are properly plugged in. Start by
unplugging the remote and the actuator cord from the control
box. Once these cords are removed check the ends for
corrosion or damage. Plug the remote cord back in by lining up
the raised tab on the plug to the grooved line on the control box
outlet. Note that these cords require some force to plug them in
fully. You will know they a correctly inserted when you here a
"popping sound". The cords will be recessed into the outlet. If
they are flush with the outside of the outlet they are not plugged
in fully and the lift will not function. Make sure you do this for
both cords.
NOT inserted fully.
If you have checked all the cords and the lift still doesn't move:
3. Check the contact points:
A. After you have fully charged the battery and checked the cords
to make sure they are properly plugged in, check to make sure
the contact points are not corroded or bent. If the contact points
are corroded take some rubbing alcohol and a q-tip and clean
off the points. After cleaning the contact points it is
recommended to put some dielectric grease on the contact
points (terminals) to help ensure good electrical contact and
prevent corrosion. Then reinstall the battery on top of the
control box. Make sure you hear a "click", which indicates that
the battery is correctly seated. The lift will not work if the battery
is not seated correctly.
Silver tabs are the contact
(terminal) points.
®
90 Swimming Pool
Fully inserted.
16
Advertisement
