Download Print this page

Pentair AQUATRAM 90 Installation And User Manual page 12

Swimming pool access lift
Hide thumbs Also See for AQUATRAM 90:

Advertisement

BATTERY MAINTENANCE
1. RECHARGE THE BATTERY AS OFTEN AS POSSIBLE. The battery power unit
is a sealed lead acid battery pack. Frequent recharges will prolong the battery life
and maintain a high cold amperage capacity. THE BATTERY CAN BE STORED
ON THE CHARGER WHEN NOT IN USE.
2. Do NOT expose the battery to freezing temperatures.
3. Do NOT expose the battery to prolonged periods of extreme heat or severe cold
temperatures.
4. Do NOT expose the battery to long periods of direct sunlight. Heat will shorten
your battery life. Optimum operating temperature is below 20 degrees Celsius
(68 degrees F.)
5. Never drop or bump the battery pack. This may result in loose or damaged
internal connections, and may bend the battery terminals.
6. Keep battery terminals clean and free from dirt and corrosion to ensure good
contact. The terminals may be cleaned using Scotch Brite or any similar product.
Clean off any corrosion or discoloration on the very top surfaces of the battery
contacts and then apply dielectric grease (supplied with lift) as shown in the
figure below.
USING THE "EMERGENCY BUTTON" on the Pool Lift Control Box
On the front side of the control box is a small recessed
button marked "emergency". Take a pen or pencil or
other pointed object and depress the "emergency"
button. This will bypass the remote control and send a
signal directly to the actuator to raise the seat out of the
pool and back to the deck or up position.
NOTE: This function will only work if there is
sufficient power in the battery, the battery is properly
attached to the control box, and the control box must
be operating properly.
11

Advertisement

loading