Viewing The Ops Pc Module Input Source - SMART PCM11-i5 User Manual

Chapter 2
Installing and using the SMART OPS PC module

Viewing the OPS PC module input source

1. Open the display's input source menu:
Display series
GX
MX100
MX (V2)
MX (V2) Pro
6000S
6000S Pro
7000R
7000R Pro
6000S
6000S Pro
7000R
7000R Pro
7000-V2
7000-V2 Pro
2. Select the OPS PC module input source.
smarttech.com/kb/171747
iQ status Procedure
N/A Open the Side Toolbar menu by tapping and sliding either
of the Side Toolbar menu handles
of the screen) towards the center of the screen, and then tap
the Input Source icon
OR
Press the Input Source button
N/A
Press the Input button
remote control.
Enabled or
Press the Input button
disabled
remote control.
Enabled
Tap the Home button
then tap Input
OR
Press the Input button
Disabled
Tap the Home button
OR
Press the Home button
remote control.
TIP
If you want the OPS PC module's input source to appear
whenever you wake up the display, tap the star in the
upper-left corner of the OPS PC module's thumbnail.
Enabled or
Tap the Home button
disabled
then tap Input
(located on either side
.
on the remote control.
on the front control panel or the
on the front control panel or the
below the screen, and
.
on the remote control.
below the screen.
or the Input button
at the bottom of the screen, and
.
on the
8