Chapter 2: Installing And Using The Smart Ops Pc Module - SMART PCM11-i5 User Manual

Chapter 2
Installing and using the
SMART OPS PC module
Viewing the OPS PC module input source
Connecting USB drives, peripherals, and other devices
Connecting external displays
You or your organization's installers can install the SMART OPS PC module in a supported SMART Board
interactive display's accessory slot following the OPS PC module's installation instructions:
Series
PCM11
PCM8
You can then view the OPS PC module's input on the display.
CAUTION
Do not install or remove the OPS PC module while the display is turned on. Ensure the power switch on
the back of the display beside the AC power inlet is in the OFF (O) position.
NOTE
For a list of SMART Board interactive displays in which you can install the OPS PC module, see the OPS PC
module's specifications.
Series
PCM11
PCM8
TIP
You can install the SMART software that is included with the display on the OPS PC module. For more
information about installing software, see the software's installation documentation.
smarttech.com/kb/171747
Installation instructions
smarttech.com/kb/171775
smarttech.com/kb/171544
Specifications
smarttech.com/kb/171761
smarttech.com/kb/171429
8
9
10
7