Logging In To An Ap Through The Console Port - Huawei AP8082DN Hardware Installation And Maintenance Manual

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Logging In to the AP
Step 1 Start the SSH client software on the terminal and access the IP address of the AP using
STelnet V2.
Step 2 Enter the user name and password as prompted, and log in to the user interface.
----End

6.10.2.2 Logging In to an AP Through the Console Port

You can connect a terminal to a Fit AP through a console cable, and then log in to the AP
using the terminal simulation software.
Table 6-39 Default parameters of a Fit AP
Parameter
Baud rate (B)
Data bits (D)
Parity (P)
Stop bits (S)
Flow control (F)
User name
Password
Issue 03 (2019-04-01)
Figure 6-174 Connecting to an AP in wireless mode
a. Configure the IP address of the terminal to be on the same network segment as the
default IP address of the AP, for example, 169.254.2.x/24 (169.254.2.100
recommended, 169.254.2.1 excluded).
b. Within the coverage of the AP, search for the SSID hw_manage_xxxx on the
terminal. After you enter the correct wireless password, the terminal can access the
WLAN.
Copyright © Huawei Technologies Co., Ltd.
Table 6-39 lists default parameters of a Fit AP.
Default Value
9600
8
None
1
None
admin
admin@huawei.com
6 Appendix
182