Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
E. Cable jacket
Procedure
Step 1 Cut the feeder cable, as shown in
Figure 6-90 Cutting a feeder cable (unit: mm)
l Ensure that the feeder cable is cut with reference to the guide in the package box of the
l After you cut the feeder cable, ensure that the cross-section of the outer conductor is
l Ensure that the feeder cable is cut at the wave crest of the outer conductor.
l The inner conductor must be beveled, as shown in
Step 2 Use a brush to remove the dirt on the cross-section of the feeder cable.
Step 3 Feed the feeder cable into the heat-shrink tubing, and cover the outer conductor of the feeder
cable with the O-ring seal, as shown in
Issue 03 (2019-04-01)
F. Outer conductor of feeder
cable
connector.
smooth, intact, and round.
Copyright © Huawei Technologies Co., Ltd.
G. Inner conductor of
feeder cable
Figure
6-90.
Figure
Figure
6-91.
6 Appendix
H. Insulation layer of
feeder cable
6-90.
100
Advertisement
Table of Contents
