Table of Contents
Advertisement
4.1 Pre-start check
• Read carefully the following pages and carry out the
operations described below in accordance with the
instructions specified.
4.2 Break-in running
NOTE: For the first 50 hours of engine operation, it is advisable not to exceed 75% of the maximum power supplied.
4.3 Starting and turning off
4.3.1
Starting
1. Check the level of the engine oil, fuel and coolant and fill
if necessary
(Par. 4.5 and Par.
2. Put the ignition key in the ignition switch.
3. Tun the key to 1 position.
4. Press the Start push button for it to start automatically.
Important
• At the first start-up, carry out the operations in point 4, 5
and 6 of Par. 6.3.
• RPM reading delay is normal.
• If engine does not start after two attempts see
Tab. 7.2
to found the cause.
4.3.2
After starting
• Make sure that all the warning lights on the control panel are off when the engine is running.
• Check for any leakages from the pipes on first start-up
1. Run at minimum speed for a few minutes according to table.
4.1
AMBIENT TEMPERATURE
≤ -20°C
from -20° C to -10°C
from -10° C to -5° C
from -5° C to 5° C
≥ 5° C
4.3.3
Turning off
1. Do not turn off the engine with a full load or when it is running at the maximum rotation speed. Leave it running at idle speed
without a load for approximately 1 minute.
2. Press the Stop push button (the engine turns off) and turn the key to position 0.
ED0053030870
_04
INFORMATION ABOUT USE
4.6).
Tab. 7.1
and
Warning
TIME
2 minutes
1 minutes
30 seconds
20 seconds
15 seconds
Important
• Non compliance with the operations described in the
following pages involves the risk of damages to the engine
and vehicle on which it is installed as well as personal and/
or property damage.
• Increase the frequency of maintenance operations in heavy
working conditions (engine starts but stops, very dusty and
hot environments, etc...).
4
19
EN
Advertisement
Table of Contents
